If you are operating a Netgear Orbi and suddenly the Orbi blinking red light, it might mean a tad scary. Generally, such kind of red light would indicate your router is facing some major problems-therefore, do not panic. These issues can usually be sorted out with a couple of troubleshooting steps.

What Does It Mean When Orbi Power Light Is Blinking Red?

The red power LED normally indicates a severe problem with the device firmware, hardware, or booting mechanism. Such an incident could occur after an interrupted update or a power outage or because of corrupt system data. The router is literally saying it cannot boot properly.

Solutions That Might Help You

Reboot Orbi Router

·         Unplug the power adapter from the router.

·         Wait for 30-60 seconds.

·         Then plug it back in, and start up the system.

·         A reboot sometimes gets rid of the problems.

Reset Orbi Router

·         If the reboot does not work, you probably have to go in for a factory reset.

·         Yes, indeed! Here is the procedure for resetting Orbi. Locate the reset button, which usually is a small pinhole. Then press and hold it for anywhere between 10 and 15 seconds until you see the power light blinking.

·         Essentially, this will restore your Orbi to its default settings, and you will need to reconfigure your WiFi.

Update the Orbi Firmware.

·         The flickering red light could very well be the symptoms of outdated or corrupted firmware.

·         Ever since it had been properly restarted, log on to the Orbi app or web interface. From there, look for an update under Administration > Firmware Update and install the latest firmware available.

Check Power Supply

·         Suppose the power adaptor malfunctions; very well can it cause the red light.

·         Make sure your router is connected to a power supply of good quality.

So. Anyway, sometimes a flickering red power light does not necessarily mean your Orbi is dead. Most times, you can have your system up and running very fast with a restart, reset of your Orbi router, and the checking that you have the latest Orbi firmware update installed.

Visit our website for more.